ALL NEW JLT SERIES 2 for 2011-2014 Mustang GT 5.0 and 2012-2013 Boss
302 NOW SHIPPING
This
new kit was designed from the ground up to work with today's
aftermarket manifolds and throttle bodies.
Released
back in 2010, our original kit has worked great on the 5.0 for over 7
years. With the release of the BOSS and now the Holly Sniper along with
85 and 90mm throttle bodies we decided to do a redesign to accommodate
these different sizes and angles.
The
all new JLT Series 2!
BIGGER,
BADDER and still the BEST!
Designed
to fit and work with the stock manifold as well as the BOSS and Holley
Sniper
It
starts with a 4" opening at the throttle body to match up to those 90mm
units. The kit comes
COMPLETE with 2 couplers. One 4" straight for the 90mm and a 4-3.5"
reducer for the stock unit.
Next
is the perfect 112mm MAF housing. Up from 107mm on the original, but
not so big to cause drivability issues. Oh and the MAX allowed in NMRA
Coyote Stock racing.
At
the MAF you attach our one off designed S&B filter. A massive
5" at the inlet with a full radiused bellmouth to huge 1" deep pleats,
this thing flows tons of air.
Finally
all this sits in our own designed Roto Molded heat shield that
utilities the factory fresh air inlet to get you the most cool air
possible.
Finish
it off with a silicone coupler and stainless clamps and you got the
BEST Intake on the market!!! NO METAL TUBING HERE!!
MOLDED
IN MAF
It’s
a full 112mm ID at the MAF area
MAF
is rotated to the inside or engine side of the tube for a more pleasing
smooth look
HEAT
SHIELD
Includes
roto molded plastic heat shield to block engine heat at idle and low
speed.
It
incorporates the fresh air inlet from the grill.
It
uses a large area to make sure the filter has tons of cool air.
KIT
INCLUDES:
•JLT
Textured Plastic Intake Tube
•4"
Silicone Coupler for aftermarket throttle bodies
•4-3.5"
Silicone reducer for stock throttle bodies
•5x7"
S&B Powerstack Air Filter
•Roto
molded Heat Shield
•HD
Clamps, 2013-14 hood insert plug & all needed hardware
EASY
INSTALL
The
design and detailed instructions help make this kit an easy install.
GAINS
AND TESTING
2-4
RWHP over our original JLT CAI on a stock GT
8-10
RWHP over our original JLT CAI on a BOSS!
10-14
RWHP over our original JLT CAI on a modded GT
We
have tested this on three different cars with different stages of mods
and all gained over the original kit. See test videos below
TUNING
A
Brenspeed specific tune is required with this kit.
574-594-9559
